If your other Mic's are working Ok thn it must be something with that Mic. I seem to have read something about florecent lighting affecting something but it may have been other than recording etc.

Any Condenser Mic should work with any Pre-amp tube or solid state. Usually there is a fairly wide range of impedeances that are compatiable. You might read the fact sheet on that Mic and see what the range of impedeance is and the range of impedeance on the Pre-amp you are using. They may be a bit too far apart to work properly. If so the resulting noise will show up most likely because you have to raise the level too much.

Ray E. Strode